Eline-technology SIP Alarm Settings Guide Manual do Utilizador descarregar pdf

Before doing the following steps, be sure the testing of hardware (alarm

–in and alarm-out device) is OK.

1: How to receive the alarm-in signals on VMS software?

You can do it as follows:

(1). Configure “Alarm Center”.

Set the IP of the PC where the VMS software runs on as the Alarm Center

Server IP, and set the port it listen to. Port 30004 is used in default.

(2). Listen to the port

Open a socket to listen to the port you set in the last step. If you can receive

the alarm-in signals from the IP camera, you can parse the alarm-in message

as the sample code did in the attachment. The sample code bind the local PC

and listen to 30004, you can modify it.

Note:

a. Our NVMS software listens to port 30004 in default. If you select this

port as the alarm port, you’d better close NVMS when testing in order to

avoiding port conflict.

b. We can mainly deal with two types of alarm: I/O and motion detection.

If you want to test the I/O alarm, you’d better disable the motion

detection.

2. How to make the alarm-out work after receive the alarm-in signals?

eLineTechnology.com

1 2

Página 1

Before doing the following steps, be sure the testing of hardware (alarm –in and alarm-out device) is OK. 1: How to receive the alarm-in signals on V

We recommend you configure the linkage parameters as we discussed before. The alarm-out will work automatically if it detects the signals. Or you can

Sem comentários

Eline-technology SIP Alarm Settings Guide Manual do Utilizador